2GIG REPEATER RPTR1-345
The 2GIG 345MHz Repeater will repeat 2GIG and Honeywell sensor signals to 2GIG panels. By adding a Repeater between the panel and sensor the system can get better range and more reliable signals in difficult RF environments. The Repeater is a plug and play device that will immediately start repeating signals when powered on. The rechargeable battery provides backup power in case of AC power loss.
Optional zone programming to supervise Tamper, AC Loss and Low Battery.
GC2: Requires FW v.1.14 or higher
GC3: Requires FW v3.1 or higher$58.40
2GIG-FT1-345 Flood and Temperature Sensor
Perfect sensor to alert the home owner of a flood or excessive change in temperature.
The 2GIG-FT1-345 is a fully supervised, tamper protected one-way 345 MHz sensor. It will monitor the ambient temperature and will detect a wet/dry flood condition. The sensor reports wet/dry conditions and temperature to the panel.
Once the sensor probe detects the presence of water for three (3) minutes, the integral transmitter will send a wet alarm transmission to the security/control panel. The probe will also send a restore (dry) report when the presence of liquid is no longer detected by the flood probe for three (3) minutes. For flood reporting, the sensor requires the installation of the supplied external flood probe. The sensor is capable of detecting clean or dirty fresh water, salt water, or tap water.
- Detects standing water that reaches the sensor probe and notifies the panel
- Sends trouble alert to the panel when the ambient temperature exceeds 84 deg. F
- Sends trouble alert to the panel when the ambient temperature falls below 42 deg. F
- Ships with long life lithium battery life (typical battery life of 5 years)
- ETL listed
- Requires Firmware Version 1.14 or later for GC2 panel and 3.1 or later for GC3
Model Number: 2GIG-FT1-345$42.00
QOLSYS IQ PANEL 2 KIT w/3 STD D/W, 1 PIR
Kit Contains –
(1) 7-inch, High-Resolution (1280 x 800 pixels) Capacitive Touchscreen.
(3) QOLQS1100P01IQ Wireless Standard Door Window Transmitter
(1) QOLQS1200P01IQ Wireless Motion Detector 35Ft 40lb PI$475.00
2GIG AT&T 3G HSPA COMMUNICATOR/MODULE (GC3GA-A)
The 2GIG-GC 3G Cellular Radio Module is a snap-in cell radio that rpovides 2-way voice to a Central Station, transmits security information to online portals, and delivers the latest Over-The-Air firmware updates to the 2GIG Control Panel.$99.00
2GIG-SDS1-345 Smoke Detector Sensor/Transmitter
Installs in between wall and existing hardwired smoke detector. Converts hardwired interconnected smoke detector systems to work with wireless alarm panels. Backup battery to send alarm transmissions in the event of power failure. Easy to see device status indicators.$38.99
DIY INDEPENDENCE PACKAGE
Free yourself from a locked out/locked down system….Control what you own, don't break your contract but get out as soon as you can! If you have a 2GIG Go Control Panel you can swap out your cell module and if needed upgrade your firmware with provided cable to save money and go Month to Month with no long term contract.$139.99
2GIG-ANT2X – 2GIG External Attic Mount GSM Antenna
External Attic Mount GSM Antenna. Installs in attic above Control Panel.$38.90
Evolve Plug-in Lamp Module, 300W, dimmable
Looking for a way to control your home without any wiring? Try the HomePro RF system from ACT, featuring “Z-Wave” technology! Z-Wave technology is a radio frequency-based system for communicating between controllers and devices that creates a network between all the Z-Wave devices in your home. When you plug a device in, it communicates with the other devices, letting each know it is these. As each new Z-wave device is plugged in, it communicates with all the other devices, creating a “mesh”, where each device knows who it can talk to. By doing so the furthest devices can talk to each other, by messages relayed through devices in between them!$58.40
Evolve Plug-in Lamp Module, 300W, dimmable EVOLDM-15
Looking for a way to control your home without any wiring? Try the HomePro RF system from ACT, featuring “Z-Wave” technology! Z-Wave technology is a radio frequency-based system for communicating between controllers and devices that creates a network between all the Z-Wave devices in your home.$58.40